Sunbeam 2388, 2368 Assembling The Stand Mixer, Attaching The Turntable, Adjusting The Turntable

Models: 2368 2388 2369 2386 2367

1 56
Download 56 pages 32.38 Kb
Page 5
Image 5
ASSEMBLING THE STAND MIXER

ASSEMBLING THE STAND MIXER

Before assembling the mixer, be sure the speed control dial is in the OFF position and the electric cord is unplugged.

ATTACHING THE TURNTABLE

Place the revolving turntable into the base of the stand by pressing the turntable into the center hole of the adjustment slot until it snaps into place.

ADJUSTING THE TURNTABLE

The turntable must be adjusted depending upon which bowl size is being used (see “Adding the Mixing Bowl”). To adjust, press down on the turntable locator switch and slide switch to the proper icon.

Ball Bearing

Extension

Attaching and Removing the Mixer Head

To attach the mixing head, press in on the mixer-release trigger, located at the rear of the stand.

Place the mixer head on the stand so that the metal pivot on the bottom of the mixer head goes into the latched opening on the top of the stand.

Mixer

Head

Metal

Mixer-Release ATTACHING THE TURNTABLEADJUSTING THE TURNTABLE Pivot

Trigger

ADDING THE MIXING BOWL Stand

As you release pressure from the mixer-release trigger, the top of the latch should clamp around the metal pivot. Once the mixing head is lowered into position, it will lock into place.

To raise the mixing head, press the head lock button downward while pulling up on the handle of the mixing head. Once unlocked, the mixing head can be removed by pressing the mixer release trigger.

Latched Opening

Mixer-Release

Trigger

Be sure the mixer head is securely in position before using.

NOTE: This mixer is NOT intended for use away from the stand.

ADDING THE MIXING BOWL

Move the turntable locator switch to the proper setting - the large bowl icon if you are using the large bowl; the small bowl icon if you are using the small bowl. Place the desired mixing bowl onto the turntable.

Mixing bowls should NEVER be used in a conventional oven, microwave oven, on top of the range or on any other heated surface.

If mixing bowls are scratched

or chipped, do not use mixer. Mixer bowl should not be used to blend in hot liquids.

5

Page 5
Image 5
Sunbeam 2388, 2368 Assembling The Stand Mixer, Attaching The Turntable, Adjusting The Turntable, Adding The Mixing Bowl