Genie POWERLIFT 900, 1200/1500 Safety Features, opener features, Infrared Protection Function

2 Features

Begin here onlY after completing assembly and installation of the opener. Review the Assembly and Installation poster to ensure all steps have been performed.

Contact your Genie® Professional Dealer for an installation poster, if needed, or call 1-800-35GENIE. You may also visit www.geniecompany.com to download a PDF file.

SAFETY FEATURES

Safe-T-Beam®(STB) Non-Contact

Reversing System

Puts an invisible beam across the door opening. The door stops and reverses to the full open position if anything passes through the beam. LED indicator lights on the powerhead and on the STBs provide a self-diagnostic code if an operational problem exists.

Safe-T-Reverse®Contact Reversing System Automatically stops and reverses a closing door within two seconds of contact with an object.

Automatic ForceGuard™ Control Automatically sets the force required to fully open and close the door for maximum safety.

Watch Dog™ Monitoring System

Monitors the Safe-T-Beam®system to ensure proper functionality and will automatically stop and reverse a closing door if a problem

is detected.

Manual Emergency Release

Manually releases door from door opener. Used during a power failure or other emergency to allow manual opening and closing of door.

SmartSet™ Electronic Programming Easily adjust the programming to reduce opening speed to a desired rate, vary limits and force, and program new remotes.

Automatic Lighting System

Two bulb lighting system supplies light for safer evening exits and entries. Turns ON when door is activated and automatically turns OFF 4 minutes later.

Integrated Motion Detection (Not available on all models)

Some units have motion detection built into the powerhead. Lights automatically turn ON when motion is detected for much safer movement through the garage. Lights will turn OFF after 4 minutes of no motion.

4

opener features

INTELLICODE® 2 Access Security System A new generation superior encryption system that enhances the security of the door opener by continuously changing the access code each time the remote is used. The door opener re- sponds to each new code only once. An access code copied from a working system and tried again, will not control the door opener.

Wall Console

Operates door opener from inside garage. The wall console has an indicator light with: Open/Close, Sure-Lock™, and independent light control buttons.

Home Link and Car2U® compatible. Refer to the programming instructions on page 11.

NOTE: Use this manual ONLY after completing assembly and installation of opener. Review Assembly/Installation Instructions poster. Check that all steps have been completed.

Contact your Genie® Professional Dealer for an Assembly/Installation Instructions poster, if needed, or call 1-800-35GENIE. You can also go to www.geniecompany.com to download a printable file.

INFRARED PROTECTION FUNCTION

1.The Safe-T-Beam®has no effect on the door during an opening cycle.

2.If the Safe-T-Beam®detects an obstruction when trying to close the door, it will not allow the door to close.

3.When the garage door is closing, if Safe-T-Beam®is interrupted by a person or obstacle, the garage door will stop its downward travel and reverse automatically to its fully opened position.

4.If the Safe-T-Beam®System fails, loses power, or is installed improperly, press and hold the wall console “open/close” button until the door reaches its fully closed position. If you release the “open/close” button on the wall console during the closing movement, the door will reverse automatically to its fully-opened position.

G999-393 Manual-ScrewBeltChain-EN indd 4 7/13/12 10 17 AM