Giant 1-Feb manual Assigning IP Information to the Hub FastHub 400M Models

Assigning IP Information to the Hub (FastHub 400M Models)

Assigning IP Information to the Hub (FastHub 400M Models)

After you install the hub and connect it to a management station, you can assign IP information to the hub. IP information identifies the hub to the network and is required to manage and monitor the hub through the FastHub 400 series Hub Manager, the CLI, or SNMP.

You can assign IP information to the hub by following the hub start-up prompts displayed from a terminal emulation program on your management station.

You should contact your system administrator for the following information:

•

•

•

Hub IP address

Subnet mask (netmask)

Default gateway (router)

To assign IP information to the hub, follow these steps:

Step 1 From your management station, start the terminal emulation program.

After POST completes, the Continue with configuration dialog? prompt appears on the management station, and you can then follow the prompts to assign IP information to the hub.

Step 2 From the terminal or PC, enter Y:

Continue with configuration dialog? [yes/no]: Y

Step 3 Enter the IP address (for example: 10.1.105.20):

Enter IP address: 10.1.105.20

Step 4 Enter the subnet mask (IP netmask) (for example: 255.255.255.0):

Enter IP netmask: 255.255.255.0

2-16FastHub 400 10/100 Series Installation and Configuration Guide