Connecting to the Console Port | Giant 1-Feb manual

Connecting to the Console Port (FastHub 400M Models)

Step 2 Connect one end of the supplied rollover console cable to the console port, as shown in Figure 2-8.

Caution Do not connect an actual telephone line, an ISDN line, or an Ethernet cable to this console port. Damage to the hub can result. Make sure you use the supplied RJ-45-to-RJ-45 rollover cable and adapters to connect the console port to the management station or modem.

Figure 2-8 Connecting to the Console Port

RATING
100-127	/ 200-240 V~
2A /1A	50 / 60 Hz

	DC INPUTS FOR REMOTE
UP	POWER SUPPLY
UP	SPECIFIED IN MANUAL
CONSOLE	+5V @6A, +12V @1A
	DC INPUT
DOWN

MEDIA MODULE

Supplied RJ-45-to-RJ-45 rollover console cable

14256

Step 3 Attach the appropriate adapter, such as the supplied RJ-45-to-DB-9 female DTE adapter (labeled Terminal), to a management station or modem.

Note If you are connecting the hub to a Sun workstation (or to a management station with a female DB-25 serial connector), use a male-to-male gender changer to attach the supplied RJ-45-to-RJ-45 rollover cable and a RJ-45-to-DB-25 female DTE adapter to the management station.

Step 4 Connect the other end of the supplied rollover cable to the adapter.

Connector and cabling speciﬁcations for the console port are in the Appendix B, “Connector and Cable Speciﬁcations.”

Now that the hub is connected to a management station, you can assign IP information to the hub (see the “Assigning IP Information to the Hub (FastHub 400M Models)” section on page 2-16).

Installing and Starting Up the Hub 2-15