Gigabyte GA-7VT600 manual Bios file becomes F12 after updating

After system reboots, you may find the BIOS version on your boot screen becomes the one you

English

flashed.

The BIOS file becomes F12 after updating

American Release:08/23/2002

Megatrends AMIBIOS (C) 1999 American Megatrend

7VRXP F12

AMD-Athlon(tm)Processor-1333MHz Check System Health !

Checking NVRAM...Update OK 262144KB

DEL:Steup/Dual BIOS/Q-Flash F8:Boot Menu F12:Network boot TAB:Logo Auto-Detecting Pri Master..IDE Hard Disk

Auto-Detecting Pri Slave...Not Detected Auto-Detecting Sec Master..ATAPI CDROM Auto-Detecting Sec Slave.. Not Detected

( C ) American Megatrends Inc.,

62-2003-001199-00101111-040201-KT333-GA7VRXP1-

The following is an AMI BIOS menu screen. However, you can also find similar option in AWARD BIOS menu.

6.Press Del to enter BIOS menu after system reboots. When you are in BIOS menu, move to Load Fail-Safe Defaults item and press Enter to load BIOS Fail-Safe Defaults. Normally the system redetects all devices after BIOS has been upgraded. Therefore, we highly recommend reloading the BIOS defaults after BIOS has been upgraded.

Press Enter on your keyboard

AMIBIOS SIMPLE SETUP UTILITY - VERSION 2.00

(C) 2001 American Megatrends, Inc. All Rights Reserved

STANDARD CMOS SETUP		INTEGRATED PERIPHERALS
BIOS FEATURES SETUP		HARDWARE MONITOR & MISC SETUP
CHIPSET FEATURES SETUP		SUPERVISOR PASSWORD
POWER MANAGEMENT SETUP		USER PASSWORD
PNP / PCI CONFIGURATION		IDE HDD AUTO DETECTION
LOAD FAIL-SAFE DEFAULTS		SAVE & EXIT SETUP
LOAD OPTIMIZED DEFAULTS		EXIT WITHOUT SAVING
ESC: Quit	: Select Item		F5: Old Values F6: Fail-Safe Values
F7: Optimized Values	F8: Dual BIOS/Q-Flash		F10:Save & Exit
	Load Fail-Safe Defaults

GA-7VT600(-L) Motherboard - 66 -