Important Information
It is important when installing front control gas hobs, that the work top cut out is the same as is quoted in this installation manual. If the cut out is too large, then batons must be fit- ted to the front, rear and sides - to correct the discrepancy and ensure the correct fit. Please ensure that if batons are fitted they are level with the top surface of the work top Please ensure that the seal for the hob has full contact with the work top surface.
There are two ways to install the clamps, depending on the thick- ness of the work top, please measure the thickness of your work top and ensure that the correct method is used. Both methods are detailed in the installation manual.
Failure to follow these instructions can lead to exessive force being applied to the basetray, which results in the clearence between the control knob and the hob top pressing being reduced. This can effect the opera- tion of the gas control, and the igni- tion.
Base Tray
GDHA specified dimensions with batons
Existing dimension without batons
14
