GM JDP40 manual Installation Instructions, Preparing the Opening

Installation Instructions.

Read these instructions completely and carefully.

Preparing the Opening

NOTES:

•Installation of a listed microwave oven or cooking appliance over the cooktop shall conform to the installation instructions packed with that appliance.

•To eliminate the hazard of reaching over heated surface units, cabinet storage space located above the surface units should be avoided. If cabinet storage is to be provided, the hazard can be reduced by installing a range hood that projects horizontally a minimum of 5" beyond the bottom front edge of the cabinets.

Operating	Instructions
Care and Cleaning
Installation	Instructions
Troubleshooting Tips

ANTI-TIP BRACKET

AT REAR OF RANGE

NOTE: Two sets of holes are provided under anti-tip bracket. Bracket is attached in the upper hole position at the factory.

COUNTERTOP CUTOUT TOP VIEW

No obstructions on

23-1/2”

Inside back wall of

underside of countertop

1-1/2”

cabinet or rear wall

in this area

1-1/2” Min.

5/16” Min. Flat

29-3/8”

7”

Adjoining

11”

vertical

26”

cabinet or

Front

wall above

Face of

22-7/8”

countertop

Cabinet

30”

29” Exact

1-1/8”

Smooth Cut

3-3/8” Min.

Overhang

20”

(both sides)

Customer Service

**NOTE: 24″ minimum clearance between the cooktop and the bottom of the cabinet when the bottom of wood or metal cabinet is protected by not less than 1/4″ flame retardant millboard covered with not less than No. 28 MSG sheet metal, 0.015″ stainless steel, 0.024″ aluminum, or 0.020″ copper.

30″ minimum clearance when the cabinet is

22unprotected.

When replacing an existing GE family drop-in range, the new range and existing cutout may be installed with the supplied end cap filler blocks and the lower filler trim panel.

Do not pinch the power supply cord between the range and the wall.

Do not seal the range to the side cabinets.