Getting Started

Figure 1..1

Side view of 9p23 portable handset

Figure 1..2

Bottom view

Battery lock tabs

Locked position

Unlocked position

Figure 1..3

Desktop charger

Figure 1..4



Battery installation

1.Attach the battery to the back of the handset by sliding the tabs on the battery into the appropriate slots on the handset, then press down firmly (see Figure 1.1).

2.While holding the battery firmly against the handset, push the battery lock tabs located on the bottom of the handset outward to the “locked position” (see Figure 1.2) to secure the battery.

3.To remove the battery, while holding the battery firmly against the handset, push the battery lock tabs inward, to the “unlocked” position and pull the battery off the handset.

Charge the battery

The desktop charger will charge the battery while it is attached to the handset as well as charge a single battery pack by standing the battery pack in the compartment of the desktop charger. The battery should be fully charged before using the 9p23 portable handset.

Charge the battery when attached to the handset

1.Connect the AC adapter to the desktop charger (see Figure 1.3).

2.Plug the AC adapter into a wall outlet.

3.Place the handset into the desktop charger (see Figure 1.4). The red indicator light located on the bottom right corner of the desktop charger indicates charging is in progress when the handset is properly seated on the desktop charger.

4.A green indicator light on the desktop charger indicates the 9p23 portable handset is fully charged when the handset is properly seated on the desktop charger.

The available rack charger is similar to the desktop charger. For more information, please refer to the Ascom RC23 Charging Rack Installation Guide.

Page 7
Image 7
GN Netcom 9p23 manual Getting Started, Battery installation, Charge the battery