Go-Video DVD 22 owner manual Digital Audio Connections, For Your Reference, Dolby Digital and DTS

DIGITAL AUDIO CONNECTIONS

Optical Digital Audio Connection Notes

•Remove the dust protection cap from the optical digital audio output and connect the cable firmly so that the configurations of both the cable and the connector match.

•Keep the dust protection cap and always reuse the cap when not using the connector.

Audio Output From the Unit’s Optical/ Coaxial Digital Audio Output Connector

Disc:	Sound recording	Optical/coaxial digital
	format:	audio output:
DVD	Dolby Digital	Dolby Digital bitstream
		(2-5.1ch) or PCM
		(2ch, 48kHz, 16-bit)††
	Linear PCM	Linear PCM (2ch)
	(48/96kHz,	(48/96kHz,
	16/20/24-bit)	16/20/24-bit)
	DTS	Bitstream or no
		output††
CD	Linear PCM	Linear PCM
		(44.1kHz sampling)

††Digital format must be selected as “Original” or “PCM” in Digital Output menu (see “Digital Output” section on page 19).

For Your Reference:

•Dolby Digital is a digital sound compression technique developed by the Dolby Laboratories Licensing Corporation. Supporting 5.1- or 7.1- channel surround sound depending on the specific disc, as well as stereo (2-channel) sound, this tech- nique enables a large quantity of sound data to be efficiently recorded on a disc.

•DTS is another digital audio technology developed by Digital Theater Systems, Inc. It supports 5.1 and 6.1 surround sound, depending on the specific disc, thanks to a sophisticated encoding system.

•Linear PCM is a signal recording format used in CDs. While CDs are recorded in 44.1kHz/16-bit, DVDs are recorded in 48kHz/16-bit up to 96kHz/ 24-bit.

•If you have a Dolby Pro Logic Surround decoder connected to the DVD 22’s analog audio out con- nectors, thanks to the “Downmix” function of the DVD 22 you will obtain the full benefit of Pro Logic from the same DVD movies that provide full 5.1- channel Dolby Digital soundtracks, as well as from titles encoded with Dolby Surround.

•The DVD 22 is designed to digitally output 96kHz PCM audio with a 96kHz sampling rate. The 96kHz indicator will light in the display. However, some 96kHz DVDs may include copy protection codes that do not permit digital output. For full 96kHz fidelity from these discs, use the analog outputs of the DVD 22. If your surround processor converter does not support 96kHz PCM audio, you must use the DVD 22 analog outputs for full 96kHz fidelity with these discs.

•When connecting a receiver or surround processor with a digital input but which does not contain a Dolby Digital or DTS decoder, be sure to select PCM as the initial setting in the Digital Output menu (see page 18). Otherwise, any attempt to play DVDs may cause such a high level of noise

that it may be harmful to your ears and damage your speakers.

•CDs can be played as they would in a conventional CD player.

Dolby Digital and DTS

Both Dolby Digital and DTS are audio formats used to record 5.1-channel audio signals onto the digital track of film. Both of these formats provide six separate channels: left, right, center, left rear, right rear, and common subwoofer.

Remember that Dolby Digital or DTS will only play

5.1-channel sound if you’ve connected the optical or coaxial output of the DVD 22 to a DTS or Dolby Digital receiver or decoder (see page 13) and if the disc was recorded in the Dolby Digital or DTS format.

NOTE: Some first-generation DTS decoders that do not support DVD-DTS interface may not work properly with the DVD/CD player.

16 DIGITAL AUDIO CONNECTIONS