50.Wrap the Rear Cable (94) under a Small Pulley
(74).Attach the Small Pulley, a Small Cable Trap (93), and two Half Pulley Guards (91) at the sec- ond hole from either end of the two Pulley Plates
(92)with an M10 x 48mm Bolt (125) and an M10 Nylon Locknut (153). Make sure that the Cable
Trap and the Half Pulley Guards are oriented as shown.
51.Attach the Rear Cable (94) inside the Weight Carriage Frame (18) with an M10 x 55mm Bolt (127), two M10 Washers (148), and an M10 Nylon Locknut (153).
52.Identify the Low Cable (80). Route the threaded end of the Cable through the Foot Plate (15) and the Center Upright (13).
Wrap the Low Cable (80) under a Large Pulley (165). Attach the Large Pulley inside the Center Upright (13) with an M10 x 93mm Bolt (129), two M10 Washers (148), two M10 x 25mm Spacers (169), and an M10 Nylon Locknut (153).
50 |
|
|
91 |
|
|
| 94 |
|
153 | 74 | 93 |
|
| |
|
| 91 |
| 92 | 125 |
51 |
|
|
153 | 148 | 18 |
|
| 148 |
|
| 127 |
|
| 94 |
52 |
|
153 | 165 |
148 | 13 |
169 |
|
| 169 |
15 | 148 |
| 129 |
80 |
|
26
