Gal 200-500 lb | Graco EQ300C specification

Operation
8. Turn the selector valve to RINSE.	10. Align the bung handle with the pin slot, and then
	firmly push and turn the handle 90° after the pin
	is below the bracket slot. Proper engagement of
	the pin will hold the bung down until it is released.

9. Disengage the Emergency Stop.

11. Add 10 gallons (30 liters) of fresh water to the pot. Wear appropriate personal protective equipment, including an appropriately fit-tested government approved respirator suitable for the dust conditions. Add abrasive material (minimum four bags, maximum ten 50 lb (23 kg) bags of high-mass abrasive, or eight 50 lb (23 kg) bags of low mass abrasive).

NOTE: The water pump will not work unless the

Emergency Stop is disengaged.

1 2

10 gal	200-500 lb
10 gal	(90-227 kg)
(30 L)

12. Use a garden hose or the rinse hose to wash the abrasive into the pot and clear any abrasive from the bung and bung seal.

334667B

Page 12

Image 12

Contents

Important Safety Instructions EcoQuip Vapor Abrasive Blast System Models Related Manuals Dust and Debris Hazard Burn Hazard OEM System Guidelines MetricCompressor Size and Hose Length Minimum ID Metric System Component Identification EQ300C and EQ600C DataTrak Controls KeyDataTrak see DataTrak Controls, Pressure Relief Procedure Checklist Before Starting Operation Connecting the Blast Hose and Air Hose Setting Up the Equipment 10 gal 200-500 lb Ti24824a 0 0 0 8 8 0 0 0 3 Blasting Tips Blasting on Higher Surfaces Metering Valve Settings Grit Size Blast Pressure Abrasive Dose Blast Angle GeneralWood Steel Using the Wash Feature Refilling the Pot with Abrasive Shutting Down Operation Winterizing the Equipment Troubleshooting Problem Cause SolutionSee Cleaning the Auto-Vent Valve, See Repairing the Main Air Regulator See Setting Up the Equipment, See Repairing the Diaphragm ValveProcedure see Shutting Down, Intact. See Hose Schematic, Properly. See Hose Schematic, Metering Valve Settings,See Pressure Relief Procedure, Setting Up the Equipment, If flushing does not solve the problem, see Troubleshooting Examples Checking for Leaks Pneumatic Blast Control Circuit Repairing the Main Air Regulator Perform Pressure Relief Procedure,Repair Flushing the Diaphragm Valve Repairing the Diaphragm Valve Perform the Pressure Relief Procedure, Cleaning the Auto-Vent Valve Replacing the DataTrak Battery Replace BatteryApproved Batteries Replacing the DataTrak Fuse Replace FuseApproved Fuses DataTrak Part Series Letter Fuse Required Parts EQ300C and EQ600C EQ300C and EQ600C Parts List Pressure POT Enclosure Enclosure Parts List Part Description Qty Pressure Pot Parts List Pressure PotRef. Part Description Qty Hose Schematic Vapor Abrasive Blast Systems and Accessories EcoQuip Skid SystemsEcoQuip Trailer Systems Model Series Brakes Mobile/Skid Units Trailer UnitsModel Model Description Hoses NozzlesModel Description Type Length Blast Control Other Accessories Common Spare Parts Dimensions Technical Specifications EQ300SEQ600S Graco Extended Warranty for EcoQuip Components Graco Information

Graco EQ300C manual gal 200-500 lb

Models: EQ300C

10 gal

200-500 lb

(30 L)