Graco 695, Mark VII, Mark IV, Mark X, 795, 1095, 1595 Pressure Relief Procedure

Pressure Relief Procedure

Pressure Relief Procedure

Follow the Pressure Relief Procedure whenever you see this symbol.

This equipment stays pressurized until pressure is manually relieved. To help prevent serious injury from pressurized fluid, such as skin injection, splashing fluid and moving parts, follow the Pressure Relief Procedure when you stop spraying and before cleaning, checking, or servicing the equipment.

1.Turn power OFF. Wait 7 seconds for power to dissipate.

2. Engage trigger lock.

ti18199a

3. Remove guard and SwitchTip.

ti2769a

4.Turn pressure to lowest setting. Trigger gun to relieve pressure.

ti22937a

5.Put drain tube in pail. Turn prime valve down to DRAIN position. Leave prime valve in DRAIN posi- tion until you are ready to spray again.

ti14842a

ti2595a

6.If you suspect the spray tip or hose is clogged or that pressure has not been fully relieved after follow- ing the steps above, VERY SLOWLY loosen tip guard retaining nut or hose end coupling to relieve pressure gradually, then loosen completely. Clear hose or tip obstruction.

332916C 13