Typical Installation
A
B
C
KEY
ADelta Spray Gun
See page 4 for gun part numbers.
BFluid Inlet; 3/8 npsm
CAir Swivel Inlet; 1/4 npsm
DAir Hose
Recommend 5/16” (7.9 mm) ID hose Optional 3/8” (9.5 mm) ID hose
EAir
FAir Regulator
GAir Filter
HAir Supply Line
The Delta Spray HVLP spray gun was designed to produce the highest quality finish with today’s fluids as well as the Low V.O.C. (volatile organic compound) fluids of tomorrow.
This spray gun can spray most coatings or finishes currently being used for automotive, industrial, aero- space, marine, wood, plastic and architectural applica- tions, while easily operating from any paint delivery system, including cups, pressure pots, or remote pumps for production line operation.
The spray gun typically utilizes 40 psi (280 kPa, 2.8 bar) inbound air pressure to produce high quality paint finishes at 10 psi (70 kPa, 0.7 bar) atomizing air pres- sure.
The air regulator must have a minimum air flow capacity of 30 scfm at 100 psi (0.7 MPa, 7 bar) air pressure. Refer to the Pressure Drop Charts, page 11.
E FG H
D
07600A
Ventilate the Spray Booth
WARNING
To prevent hazardous concentrations of toxic and/or flammable vapors, spray only in a properly ventilated spray booth. Do not operate the spray gun unless ventilation fans are operating.
Check and follow all of the National, State and Local codes regarding air ex-
haust velocity requirements.
Check and follow all local safety and fire codes.
