Graham Field MM7114, Mp7074, Mp7114, Mp7174 manual Ssembly Optional foot board Embedded Staff Control

Assembly - OPTIONAL foot board EMBEDDED STAFF CONTROL

Item #	Qty	Part #	Description
	STAFF CONTrOL ASSEMBLy KIT (ZL788053) INCLuDES:
1	1	Z53650	Std. Oak Head- & Footboard (with cut out)
2	1	999-0775-901	Staff Control Assembly with Cables
3	1	999-0775-006G	Wide Staff Control Shroud
4	6	100-5506-002	#6 x .50” Phillips Truss Head Screws (Blk)
5	3	100-1100-024	4” Nylon Cable Tie
		Mounting Tube to Main Frame Hardware
6	2	100-7931-007	5/16 x 1.50” Clevis Pin w/hole (existing)
7	2	100-2001-006	1-9/16 x .072 Hair Pin Clip (existing)

1.Assemble the footboard mounting tubes to the “staff control footboard” as shown on the previous pages if not already assembled. Note that the standard footboard does not have the cut outs for the staff control assembly. A separate footboard with cut outs must be ordered for the staff controller option.

2.Facing the footboard from the foot-end of the bed, carefully thread the male and female staff control cables through the hole in the footboard and position the staff control assembly (#2) into the pre-formed slot on the footboard, making sure all screw holes line up correctly. Using two black

#6 X .50” Phillips Truss Head Screws (#4), from the back of the footboard secure the Staff Control via the outermost holes.

3.Place the Staff Control Shroud (#3) over the cables on the back of the footboard and attach with four black #6 X .50” Phillips Truss Head Screws (#4). Lightly tighten all screws with a phillips screwdriver. Tie the cables to the mounting tubes with ties (#5).

4.Insert the Footboard Mounting Tubes into the Main Bed Frame Tubes so that the holes match up as shown. Secure with two 5/16 x 1-1/2” Clevis Pins (#6) and Hair Pin Clips (#7) (1 each per bed frame tube).

5.Unplug the Pendant cable from the Extension Cable that’s already attached to the left side frame rail at the foot end of the bed.

6.Plug the male staff control cable into the cable extension that has been plugged into the control box in the HB Port. Plug the Pendant cable into the female staff control cable.

7.Tighten all screws on the Footboard with a phillips screwdriver. Be careful not to overtighten.

close-up of Hair pin clip (#6) inserted into hole in clevis pin (#7)

to safely remove Hair pin clip grasp on circular end and pull.

Tools Needed:

(1) Phillips Screwdriver

Basic American Medical products, a division of GF Health products, Inc. • Matrix II • rev d Manual p11