ASSEMBLY OF U-LEVERS TO STD. CASTER CARRIAGE - 999-0807-955G
Detail B Locking caster assembly on right side of Head end
Detail a U-Lever to caster Brackets (typical assembly)
Detail c non-Locking caster assembly on Left side of Foot end
Item # | Qty. | Part # | Description |
1 | 1 | 999-0807-903G | Foot U-Lever Weldment |
| | | |
2 | 1 | 999-0807-913G | Head U-Lever Weldment |
| | | |
3 | 4 | 999-0775-001 | Half Moon Cap |
| | | |
4 | 4 | 999-0779-100 | 1/2-13NC x 2.50” Long Button Head Cap Screw (T55) |
| | | |
5 | 8 | 100-8601-001 | .516ID x 1.25”OD x .062”Thk. Nylon Washer |
| | | |
6 | 4 | 100-6750-006 | 1/2-13 Low Nylon Lock Nut |
| | | |
| Standard Caster Carriage Assembly 999-0807-955G Includes the following parts |
7 | 1 | 999-0807-905G | Caster Carriage Weldment |
| | | |
8 | 8 | 999-0775-001 | Half Moon Cap (on Locking Carriage) |
| | | |
9 | 2 | 100-6330-061 | 3” Twin Non-Locking Caster |
| | | |
10 | 2 | 100-6330-062 | 3” Twin Locking Caster |
| | | |
11 | 4 | 100-6744-001 | 7/16-14 Nylon Lock Nut |
| | | |
12 | 4 | 100-4700-017 | 1.00” x 2.00” Rectangular End Cap |
| | | |
13 | 4 | 100-4200-004 | 1.25” Square Plastic Plug |
| | | |
14 | 4 | 100-4717-002 | 1.75” x 10-12GA Round End Cap |
| | | |
the standard caster carriage (999-0807-955G) should come pre-assembled. callouts for replacing the casters and caps on both the head and foot end (details B & c) have been included for your convenience. to attach or detach the standard caster carriage from the Matrix II u-levers, please follow the instructions below.
1.place the four Half Moon caps (#3) into the bottoms of both u-levers (#1 & #2) and into the four upright mounting brackets on the caster carriage.
2.Locate the four 1/2-13 x 2.50” Button Head cap screws (#4) and, from the outside, insert them in the bottom holes of the u-levers.
3.place a nylon Washer (#5) onto the ends of each of the exposed ends of the cap screws. carefully position the u-lever legs onto the upright brackets so that the nylon washers rest between them. push the cap screws through the holes in the upright brackets.
4.slide the remaining nylon Washers (#5) onto the cap screws and secure using four 1/2-13 nylon Lock nuts (#6). tighten all hardware using a 5/16 crescent/socket wrench and a t55 torx wrench.
Basic American Medical products, a division of GF Health products, Inc. • Matrix II • rev d Manual | p29 |
