Graham Field MM7174, Mp7074, Mp7114 Ssembly standard wallsaver with optional trapeze positioning

A ssembly - standard wallsaver (with optional trapeze positioning)

1.The Matrix II 709 standard wireform wallsaver is easily attached to the head-end of caster carriage. Begin by positioning the wallsaver (#2) on the head end with the exposed ends (with flat insert tabs) facing the foot- end of the bed.

2.From the inside, locate the bottom last hole in the carriage bracket on both sides of the bed. Holding the wallsaver in a 45° position as shown, squeeze its sides inward toward center and insert the ends of the wallsaver into the bracket holes. (See Detail A)

3.Carefully lower the wallsaver downward until it rests on the floor. The flat insert tab will turn within the bracket hole, locking the wallsaver into place. (See Detail B).

4.The position of the wallsaver is very important on the Matrix II bed. It has been designed so that the bed will be kept a safe distance from the wall when raising or lowering the bed, thus preventing damage to the bed or resident/facility walls.

NO SPECIAL Tools REQUIRED

FLAt tAB	FLAt tAB Locks Into
Inserted	cArrIAGe BrAcket
so tHAt It	BY turnInG It
Is pArALLeL	perpendIcuLAr
WItH sLot In	once It Is
cArrIAGe BrAcket	InsIde HoLe

FLAt Insert tAB

Item #	Quantity	Part #	Description
1	Reference	999-0807-955G	Standard Caster Carriage Assembly
			(Also works on Locking Carriage Assembly 999-0807-958G)
2	1	999-0779-180	Standard Wireform Wallsaver - 76”, 80”, or 84”

WALLsAver posItIon For trA- peZe

stAndArd WALLsAver posItIon

cArrIAGe BrAcket For 80” Bed

Basic American Medical products, a division of GF Health products, Inc. • Matrix II • rev d Manual p13