Grandstream Networks 486 user manual Call Features

HandyTone-486 User Manual Grandstream Networks, Inc.

1.A presses FLASH (on the analog phone, or Hook Flash for old model phones) to get a dial tone

2.A then dial C’s number then # (or wait for 4 seconds), A and C now in conversation.

3.Then A can hang up.

NOTES:

•When intended Transfer failed, if A hangs up, the HandyTone 486 will ring user A back again to remind A that B is still on the call, by pressing FLASH or Hook again will restore conversation between A and B.

5.2.6Send and Receive PSTN Calls Through PSTN Line Port

Starting with HandyTone 486 Rev:2.0, user will be able to send and receive calls from PSTN. To receive PSTN calls, simply make phone off hook when the analog phone rings. To make a PSTN call, simply press *00 (default, or any number configured in web configuration page) to switch to the PSTN line and get dial tone and call out using the PSTN line.

5.3Call Features

Grandstream HandyTone series support a list of call features: CallerID Block(or Anonymous Call), Disable/Enable Call Waiting, Call Forward on Busy, Delay, or Unconditional, etc.

Following table shows the call features (* code) of HandyTone-486, to enable each call feature, simply dial the *xx code, a dial tone will be heard after the dialed code, either hang up or dial the number and # sign for Call Forward.

Key	Call Features
*30	Block CallerID (for all-config change)
*31	Send CallerID (for all-config change)
*67	Block CallerID (per call)
*82	Send CallerID (per call)
*50	Disable Call Waiting (for all-config change)
*51	Enable Call Waiting (for all-config change)

12