Troubleshooting - Controller Alarms
The first step in troubleshooting the unit is to check the
DDC Controller
Check the screen on the DDC for an alarm condition. If the DDC is
in an alarm condition, a message will show on the DDC screen.
The DDC is located in the main control center. If the DDC is in alarm condition, the alarm button will blink red. Press the alarm button to see the specific condition or to reset the DDC. Refer to the DDC Installation Operations and Maintenance manual for detailed information on fault codes and see the
Phase Monitor
The phase monitor has two LED indicator lights, one red and one green. Green indicates proper operational status, red indicates the unit has detected a fault and is in alarm condition.
Variable Frequency Drive (VFD)
Variable frequency drives have a display screen that will show an alarm condition. If a fault such as a voltage spike occurs, the VFD will go into alarm and will not reset until a hard restart is performed. See the
FX05 Furnace Controller
Present only if an indirect
The FX05 furnace controller will display an alarm condition if present. The controller will be found in the furnace control cneter. See the
furnace installation, operation and maintenance manual and the controller manufacturer’s
28Model