Grizzly G0492 manual Using the Faceplate, egdXZYjgZhdcPage 17idbdjciiZVXZeaViZ#

Using the Faceplate

I]Z [VXZeaViZ XVc WZ jhZY id ijgc cdc"Xna^cYg^" XVaeVgihdg[dgd[["XZciZgijgc^c\WnXaVbe^c\i]Z ldg`e^ZXZidi]Z[VXZeaViZ#

To install the faceplate:

GZ[Zgidi]ZMounting the Chuck and Faceplate

egdXZYjgZhdcPage 17idbdjcii]Z[VXZeaViZ#

To load a workpiece:

1# Hjeedgii]Zldg`e^ZXZ#

2. Ha^YZi]ZiV^ahidX`idi]Zldg`e^ZXZ#

3. AdX`i]ZiV^ahidX`VcYi]Zcijgci]ZiV^ahidX` fj^aa hd i]Z YZVY XZciZg bV`Zh XdciVXi l^i] i]ZXZciZged^cid[ndjgldg`e^ZXZ#

4. AdX` i]Z iV^ahidX` fj^aa l]Zc hj[[^X^Zci egZh" hjgZ ^h Veea^ZY id ]daY i]Z ldg`e^ZXZ ^c eaVXZ#

Note: Depending on the workpiece, some additional support may be needed.

5. HZXjgZ i]Z ldg`e^ZXZ l^i] V b^c^bjb d[ i]gZZ^cYZeZcYZciXaVbe^c\YZk^XZh#;V^ajgZ id [daadl i]^h hiZe bVn aZVY id YZVYan ^c_jgn idndjghZa[dgWnhiVcYZgh#IV`Z^cidVXXdjci gdiVi^dcVcYi]ZXjii^c\[dgXZhVeea^ZYidi]Z ldg`e^ZXZ l]Zc XaVbe^c\ id i]Z [VXZeaViZ#

Make sure your clamping application will not fail!

6. JhZ V adlZg GEB l]Zc bVX]^c^c\ ]ZVkn ZXXZcig^Xldg`e^ZXZh#

Securely clamp your workpiece and remove the chuck key! Thrown objects from a lathe/ mill can cause serious injury or death to the operator and to bystanders many feet away.

Figure 16.;VXZeaViZ^chiVaaZY#

Use a minimum of three independent clamping devices when turning eccentric workpieces. Failure to provide adequate clamping will cause workpiece to eject.

"'%" <%).'&'M(+8dbWdAVi]Z$B^aa