Grizzly G0656X manual Machine Inventory Setting Outfeed Table Height, Wood Crate Qty

MODEL G0656X

8" Jointer

w/Spiral Cutterhead

Manual Insert

The Model G0656X is the same machine as the Model G0656, except it has a spiral cutterhead. Besides the differences noted in this insert, all other content in the Model G0656 owner's manual applies to this machine. Before operating your new machine, you MUST read and understand this insert and the entire Model G0656 manual to reduce the risk of injury when using this machine.

If you have any further questions about this manual insert or the differences between the Model G0656X and the Model G0656, contact our Technical Support at (570) 546-9663 or email techsupport@grizzly. com.

Machine Inventory			Setting Outfeed Table Height
Refer to the inventory photos in the G0656			The outfeed table height MUST be level with the
Manual on Page 11. After all the parts have been
			carbide inserts when they are at top-dead-center.
removed from the crate, you should have the fol-
			If the outfeed table is set too low, the workpiece will
lowing items:
			be tapered from front to back. If the outfeed table
Wood Crate:		Qty	is set too high, the workpiece will hit the edge of
			the outfeed table during operation, increasing the
A.	Jointer Assembly	1
			chance of kickback.
B.	Cutterhead Guard	1
C.	Handwheels	2	To set the outfeed table height:
D.	Handles	2
E.	Fence Tilt Lever	1	1. DISCONNECT JOINTER FROM POWER!
F.	Push Blocks	2
G.	Spiral Cutterhead Hardware (Not Shown)		2.	Move the cutterhead guard out of the way or
	—Inserts 14 x 14 x 2	5
				remove it, and open the rear access panel.
	—Flat Head Torx Screws T20 M6-1 x 15. 10
	—L-Wrench Torx T20	1	3.	Place a straightedge on the outfeed table
	—Driver Bit Torx T20	1
				so it extends over the cutterhead and rotate
H.	Tool Hardware Bag
				the cutterhead pulley until one of the carbide
	—Hex Wrenches 2.5, 3, 4, 6mm	1 Ea
				inserts is at top-dead-center (TDC), as shown
	—Open-End Wrench 8/10, 12/14mm	1Ea
				in Figure 1.

The Model G0656X Cardboard Box and Assembly Fastener Components are identical to the cor- responding components listed on Page 11 of the G0656 Manual.

Ide9ZVY

8ZciZg

Figure 1. Cutterhead insert at top-dead-center.

Copyright © DECEMBER, 2008 By Grizzly Industrial, Inc. REVISED JANUARY, 2009 (BL)

Warning: No portion of this manual may be reproduced in any shape or form without the written approval of Grizzly Industrial, inc.

#BL11411 printed in china