Grizzly G0763 owner manual Test Run, To test run the machine

2.Install a strain relief in available hole in bot- tom of electrical cabinet, then pull incoming power cord through strain relief.

3.Connect incoming hot wires to bottom of first two terminal bar connectors, then connect incoming ground wire to grounding bar (refer to the Electrical Cabinet Wiring Diagram on Page 42 for additional details).

4.Leave slack in wires inside cabinet, tighten strain relief to secure cord, then tug on power cord outside electrical cabinet to make sure wires do not move inside cabinet.

—If wires do move when you tug on power cord outside electrical cabinet, disconnect wires, reposition cord, then tighten strain relief so that cord will not move when tugged on. Reconnect wires as instructed in Step 3.

5.Close electrical cabinet door, but leave mas- ter power switch OFF.

6.Attach a NEMA 6-15 plug to other end of power cord per manufacturer's directions (refer to Electrical Cabinet Wiring Diagram on Page 42 for additional details).

7.Connect machine to power source by insert- ing power cord plug into a matching recep- tacle.

-22-

Test Run

Once assembly is complete, test run the machine to ensure the following components are working properly:

•Grinding motor

•Coolant pump

•Emergency STOP button

•Table power feed

If you find an unusual problem during the test run, immediately stop the machine, disconnect it from power, and fix the problem BEFORE operating the machine again. The Troubleshooting table on Page 39 can help.

Serious injury or death can result from using this machine BEFORE understanding its controls and related safety information. DO NOT operate, or allow others to operate, machine until the information is understood.

DO NOT start machine until all preceding setup instructions have been performed. Operating an improperly setup machine may result in malfunction or unexpect- ed results that can lead to serious injury, death, or machine/property damage.

You MUST understand the function of the controls to safely complete the Test Run. If you are not sure how a control functions or where it is, refer to Basic Controls beginning on Page 4.

To test run the machine:

1.Push Emergency STOP button in.

2.Remove all tools used for setup from the machine.

3.Fill and operate the one-shot oiler (refer to Lubrication on Page 36 for detailed instruc- tions).

Model G0763 (Mfg. Since 8/13)