Connecting Opener Power Cables
MASTER Operator
Step 4
Insert the stripped power cable wires into the appropriate terminals on the MASTER operator terminal block. The green wire should be inserted into the GRN terminal, the blue wire into BLU, the orange wire into ORG, black wire into BLK, and the red wire into the RED terminal.
Tighten the set screws against the end of the wires. A dab of petroleum jelly on each terminal will help prevent corrosion.
Correct |
|
| Wrong |
| Wrong | |||||
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Wire | Terminal | Wire | Terminal | Wire | Terminal |
Block | Block | Block |
| GRN |
| WHT |
| BLUE BRN ORG MASTER INPUTS |
| RED |
| BLK |
Power Cable from the Operator | COM |
COM | |
| CYCLE |
| CLOSE |
| SAFETY |
| EXIT/ |
| OPEN |
| SHADOW |
| LOOP |
| CLOSE |
| EDGE |
| OPEN |
| EDGE |
| GRN BLK RED RECEIVER |
SWITCH
IN | |
M |
|
| STALL FORCE |
X |
|
A | |
| M |
SLAVE Operator
Step 5
Review the Installation Overview illustration on page 11 before proceeding.
Cut a slot into the driveway to accommodate PVC conduit (not provided). The buried conduit will protect the 40 foot power cable from automobile tires, lawn mower blades, weed eaters, and grazing animals. Pull the 40 foot second opener power cable through the conduit and secure them into the slot in the driveway.
Step 6
Strip approximately 3/16" of insulation from each wire of the 40 foot power cable. Twist each exposed wire tightly. Insert the second opener power cable upward through the right strain relief (if necessary, loosen the sealing nut). Thread approximately 4" of wire into the control box. Retighten strain relief (on the black sheath of the power cable) until the power cable locks into place.
Insert the stripped wires of the power cable into the appropriate terminals on the SLAVE operator terminal block. The green wire should be inserted into the GRN terminal, the blue wire into BLU, the orange wire into ORG, black wire into BLK, and the red wire into the RED terminal.
Tighten the set screws against the end of the wires.
Power Cable from the Slave Operator Arm
NC |
GRN |
WHT |
BLUE BRN ORG SLAVE INPUTS |
RED |
BLK |
GRN |
WHT |
BLUE BRN ORG MASTER INPUTS |
RED |
BLK |
COM |
COM |
SWITCH
20
