CONTROL BOARD SETTINGS
DIP Switches
NOTE: Leave DIP Switch #3 in the OFF position untill installation is complete, to prevent gate from automatically closing during installation.
Main DIP Switch Settings (MODES)
DIP Switch #1 - Soft Start/Stop
The Soft Start/Stop feature slowly starts the gate as it begins to open and slows the gate as it comes to the closed position. This saves wear and tear on the gate and gate opener system.
DIP Switch #2 - Warning Buzzer
The Warning Buzzer alerts you when the gate opener is beginning to either open or close the gate. It sounds for the first 2 seconds in each direction. It also sounds a warning when the gate obstructs two times in one cycle. Switching this to OFF only disables the open and close warning not the obstruction warning.
DIP Switch #3 - Auto-Close
With the
DIP Switch #4 - Push/Pull-to-Open
If your gate opens into the property the DIP Switch is set to OFF (factory). If your gate opens out from the property the DIP Switch must be set to the ON position. NOTE: if you have a
DIP Switch #5 - B2/D1 Mode
This DIP Switch must remain in the OFF position unless the gate opener is going to be used by a guard or gate attendant, who can only open the gate when constant pressure is applied to a push button control device.
DIP Switches #6 and #7
The combination of these two switches determines the amount of time the gate will remain open when DIP Switch #3 is set in the ON position.
1 | 2 | 3 | 4 | 5 | 6 | 7 | ON | |
ON |
|
|
|
|
|
|
|
|
1 | 2 | 3 | 4 | 5 | 6 | 7 | OFF | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
DIP#6 | DIP#7 | Delay Time for | ||||
|
|
|
|
|
| |
ON | ON | 15 seconds |
| |||
ON | OFF | 30 seconds |
| |||
OFF | ON | 60 seconds | ||||
OFF* | OFF* | 120 seconds (factory preset) |
| |||
DIP#5 |
|
|
| |||
ON |
| D1 mode, constant pressure to operate gate. | ||||
OFF* |
|
| B2 mode, momentary contact to operate gate. | |||
DIP#4 |
|
|
| |||
ON |
| |||||
| ||||||
OFF* | ||||||
|
|
|
|
|
| |
DIP#3 |
|
|
| |||
ON |
| |||||
OFF* | ||||||
|
|
|
|
|
| |
DIP#2 |
|
|
| |||
ON* |
| Buzzer warning enabled. | ||||
| ||||||
OFF |
| Buzzer warning disabled | ||||
DIP#1 |
|
|
| |||
ON* |
| Soft start enabled. | ||||
OFF |
| Soft start disabled. |
* Factory preset.
IMPORTANT CONTROL BOARD SETTINGS:
CONTROL BOARD DIP SWITCH #1 is factory preset in the ON position and MUST remain in the ON position. Changing this setting can damage your gate, gate opener and possibly void your warranty!
24