Connecting Accessories
If not connecting accessories skip to next section.
The GTO/PRO SW2502 can accept NORMALLY OPEN CONTACT accessories, such as; Push Button Entry Devices and Key Pads.
Refer to the sensor manufacturer’s instructions for information about installing these devices on a vehicular gate.
Make sure the power to the opener is turned off before connecting safety device wiring to the terminal blocks. Unplugging the transformer does not turn power to the opener OFF.
Accessory Input Connection:
Connect one of the accessory wires to the COMMON (COM) terminal and the other to the CYCLE CLOSE terminal on the GTO/PRO SW2502 control board.
STALL FORCE
|
| M |
N | X | A |
I |
| |
M |
|
|
COM | COM | CYCLE CLOSE | SAFETY | EXIT/ OPEN | SHADOW LOOP | CLOSE EDGE | OPEN EDGE | GRN BLK RED |
|
| RECEIVER |
Each activation of the accessory will cause the gate to cycle as follows:
OPEN 
STOP 
CLOSE 
STOP
Wire from Accessory (push button, key pad, etc.)
31
