GTO 2550, 2502 installation manual Push to Open Installation, Post Bracket Assembly, Step, minimum

Push to Open Installation

Determining The Mounting Position of The Post Bracket Assembly

Swinging gates shall not open into public access areas!

A "Push-to-Open" gate opens out from the property.

A Push-to-Open Bracket is required for this type of installation (see Accessory Catalog). If you have a pull-to-open gate (gate opens into the property), return to page 13; step 3.

In a PUSH-TO-OPEN installation the openers are installed while the gates are in the closed position.

Step 1

With the gates closed, adjust the post bracket assembly and the gate bracket until the opener is level. While holding the opener level, use C-clamps to temporarily keep the post bracket assembly and gate bracket in their respective positions on the fence post and gate.

Post Bracket Assembly

3/8" x 2" Bolt

Post Bracket

Push-To-Open Bracket (optional accessory)

Post Bracket

3/8" Washer

3/8" Lock Washer

3/8" Nut

Gate in the Open Position

Pinch Area (gray)

2" minimum

Gate in the Closed Position Pinch Area (gray)

point for the post for maximum open and closed

clearance will give the and closing the gate

area.

that you have the best position

pivot bracket, insert the 5/16" x 1 3/4" the aligned holes of the post bracket

bracket and fasten it with the 5/16"

.

If you loosened the clamp on

to achieve the optimum position, new position and recheck the gate

the gate in the open position (move the and re-clamp it if necessary).

2" minimum

32