GTO 2502, 2550 installation manual II. During Installation

IMPORTANT SAFETY INSTRUCTIONS

Entrapment Zones for a proper Pull-To-Open installation: Zone 1 – leading edge of the gate and the fence post. Zone 2 – between the gate and the gate post.

Zone 3 – the path of the gate.

Zone 4 – the space between the gate in the open position and any object such as a wall, fence, tree, etc. Zone 5 – pinch points between the opener and gate or post.

II.During Installation

1.Install the gate opener on the inside of the property and fence line. DO NOT install an opener on the outside of the gate where the public has access to it.

2.Be careful with moving parts and avoid close proximity to areas where fingers or hands could be pinched.

3.Devices such as contact sensors (safety edges) and non contact sensors (photo beams) provide additional protection against entrapment.

4.If push buttons or key switches are installed, they should be within sight of the gate, yet located at least 10 feet from any moving part of the gate (see diagram below). Never install any control device where a user will be tempted to reach through the gate to activate the gate opener.

5.Do not activate your gate opener unless you can see it and can determine that its area of travel is clear of people, pets, or other obstructions. Watch the gate through its entire movement.

6.Secure outdoor or easily accessed gate opener controls in order to prohibit unauthorized use of the gate.

Pull-To-Open Application

10'

10'

10' 10'

Moving Gate	Moving Gate
Area	Area

Driveway

NEVER INSTALL

any control device

within gray area

10'

10'

3