Sun Microsystems Sun Fire V100 Memory Installation and Removal, To Install and Remove Memory

4. Tighten the captive screw on the back of the unit.

Memory Installation and Removal

There are four industry standard PC133 memory module sockets on the Sun Fire V100 server’s system board. To see the location of the memory modules inside the server, see FIGURE 8-5or the underside of the server’s top cover.

▼To Install and Remove Memory

■If the server is not in use, go straight to Step 1.

■If the server is already in use, see “To Change Components In a Sun Fire V100 Server That Is In Use” on page 88.

1.Place the unit on an ESD surface and attach an antistatic wrist strap (see

FIGURE 8-2)

2.Remove the server’s top cover (see “To Remove the Top Cover” on page 89).

3.Insert the memory module in the next vacant DIMM socket.

The memory slots are numbered 3, 2, 1, 0. Add DIMMS in that order.

Add in this order

3 2 1

3 21

0

Remove in this order

0

FIGURE 8-5DIMM Insertion and Removal Sequence

4.Press the memory module until the latches at the sides of the socket click into place.

Chapter 8 Removing and Replacing Components 91