Sun Microsystems Sun Fire V100 manual Serial Connection Settings, 1 Serial Port Pins 1 to

8 1

A LOM

1 8

B Serial

FIGURE 3-1Serial Port Pins 1 to 8

Serial Connection Settings

The settings you need to use for a serial connection are listed in TABLE 3-2. If you need to perform binary data transfers (that is, transfers of anything more than simple ASCII character streams), use the B Serial port, as communication on the A LOM port is subject to interruption by the LOM device (see “Introduction to Lights- Out Management” on page 43).

TABLE 3-2Settings for Connecting to the Serial A/LOM or Serial B Port

Parameter	Setting
Connector	Serial A/LOM or Serial B (use Serial B for binary data transfers)
Rate	9600 baud
Parity	No
Stop bits	1
Data bits	8

Chapter 3 Communicating With the Server 21