Sun Microsystems Sun Fire V100 manual To Connect to the Server Using a Sun Workstation

■RJ-45 to RJ-45 patch cable

Both are supplied with the Sun Fire V100 server.

▼To Connect to the Server Using a Sun Workstation

1.Connect to the server using the RJ-45 patch cable and DB-25 adapter as described in “To Use the DB-25 Adapter” on page 23.

2.From a terminal session, type:

#tip /dev/term/a -9600

The tip command above is for a console that is using its ttya serial port. If you later configure your console to use ttyb, type the following to set up a tip session:

#tip /dev/term/b -9600

For information about dedicating the console to Serial B, see “Managing the Sun Fire V100 Server From the lom> Prompt” on page 43.

For information about how to power on and configure the server, go to “Powering On and Configuring the Server” on page 34.

▼To Connect to the Server Using an ASCII Terminal

1.Set up a connection between the terminal and the Sun Fire V100 server. See “To Use the DB-25 Adapter” on page 23.

2.For the General terminal settings, refer to the terminal operating manual.

24 Sun Fire V100 User’s Guide • December 2001