Sun Microsystems Sun Fire V100 manual Monitoring the Server From the LOM Shell

TABLE 5-1 Boot Modes

Mode	Description
reset_nvram	In this mode, the server returns all NVRAM data to its default
	setting. The command is equivalent to the Stop-N key combination
	for Sun keyboards. To cause the parameter to take effect, you must
	reset the server after using the bootmode command at the lom>
	prompt.
diag	In this mode, the server performs full self-diagnostics as part of the
	boot process. The command is equivalent to the Stop-D key
	combination for Sun keyboards. To cause the parameter to take
	effect, you must power off and then power on the server within 10
	minutes of using the bootmode command at the lom> prompt.
skip_diag	In this mode, the server skips the diagnostics part of the boot
	process. To cause the parameter to take effect, you must power off
	and then power on the server within 10 minutes of using the
	bootmode command at the lom> prompt.

Monitoring the Server From the LOM Shell

This section describes commands that enable you to check the status of the server and the components monitored by the LOM device.

It also describes how to view the events stored in the LOM device’s event log.

Chapter 5 Managing the Sun Fire V100 Server From the lom> Prompt 49