Sun Microsystems Sun Fire V100 manual Powering On or Resetting the Server From the LOM Shell

Powering On or Resetting the Server From the LOM Shell

Note –When a Sun Fire V100 server is connected to a power supply, it is always either fully powered on or in standby mode. To remove power entirely from the server you must disconnect its power cables or open all external circuit breakers. The methods referred to in this chapter for powering the server on and off by using lom> prompt commands are methods either of powering the server on or returning it to standby power mode. The poweroff command does not power the server off completely.

Note –All commands that involve powering on or off, resetting, or specifying the boot mode of the server require you or the named user to have r-level LOM user permission. If you have not set up any named users of the LOM device, then you have r-level permission by default. If you have set up one or more named users, then you must explicitly give them r-level permission to use these commands. For more information about user privileges, see “Setting Up LOM Privileges for Named Users” on page 54.

▼To Power On the Server or to Power Down to Standby Mode

●To power on the server, type:

lom> poweron

●To power the server down to standby mode, type:

lom> poweroff

Chapter 5 Managing the Sun Fire V100 Server From the lom> Prompt 45