Step 5
Strip the ends of the low voltage wire and twist tightly. Attach these ends to the 18 VAC OR SOLAR terminals located on the POWER INPUTS terminal block.
Be certain not to let the exposed wires touch each other!
Insert one transformer wire into an 18 VAC OR SOLAR terminal. Insert the other transformer wire into the remaining 18 VAC OR SOLAR terminal. The transformer wires can be connected
CONTROL OUTPUTS
POWER | LOCK | AUX | |
INPUT | |||
PWR | RLY | ||
|
| ||
18 VAC | LOCK | AUX | |
OR | PWR | RLY | |
SOLAR | |||
|
| ||
~ ~ |
|
|
2ND OPERATOR
GRN WHT BLUE BRN ORG RED BLK
2ND OPERATOR
MASTER OPERATOR
GRN WHT BLUE BRN ORG RED BLK
MASTER OPERATOR
to the 18 VAC OR SOLAR terminals regardless of color/polarity.
Tighten set screws against exposed end of wires.
Low Voltage Wire from AC Transformer or Solar Panel
BLACK
RED
Power Cable from Master Arm
Step 6
At the transformer, strip 1/2” of insulation from the ends of the low voltage wire. Attach wires to the transformer terminals.
Make sure the exposed wires do not touch each other!
DO NOT PLUG THE TRANSFORMER INTO AN OUTLET DURING THIS STEP! THE TRANSFORMER MUST ONLY BE PLUGGED INTO AN OUTLET DURING STEP 3 (page 15)!
Connect Battery
Step 1
Make sure the control box power switch is OFF. Remove the control box cover and slide the battery into position (terminals to the right).
ON/OFF Switch |
14GTO 4000XLS Instruction Manual © 01.10.12
