GTO 12, R4854 01, 10 installation manual Set Control Board for Push-To-Open

Set Control Board for Push-To-Open

Make sure the control box power switch is OFF. Use a small screwdriver to move the Number 3 DIP switch from the factory setting (OFF / Pull-To-Open) to ON for Push-To-Open. Turn power switch ON. The control board is now configured to push the gate open.

					FORCE	MAX	ON ON	PUSH SIMULT.	ON	ON
					STALL	MIN	ON	DIP
ON				ON	TIMECLOSEAUTO	OFF120	1 2 3 4		MODE1OFF	OFF
							STARTSOFTOFF WARNINGOFF	OPENPULL OPEN2ND..DLY
1	2	3	4	OFF

DIP#3

ON: Push-to-open operation.

OFF: Pull-to-open operation (factory setting).

Setting the Open Position Limit (Push-To-Open Installations)

Step 1	Gate in Closed
Power switch is on, gate is
	Postion
in the CLOSED position,
operator arm
fully retracted.	Control
	Box
ON/OFF Switch

Step 2

Press the transmitter to activate operator arm. The gate will begin to OPEN.

Control

Box

Gate

Opening

Step 3
When the gate reaches	Gate
the desired OPEN		Control
position, press the	Opened	Box
transmitter to
stop the gate.

Step 4
With the master
gate at the correct	T.
position, program the
open limit setting by
pressing and holding
LEARN MAST LIMIT.

S3

LEARN

MAST LIMIT S2

LEARN

2ND LIMIT S4

Learn Master Limit Button

Step 5

Press the transmitter again to allow the gate to return to the fully CLOSED position.

Gate is now programmed

Gate in Closed
Postion
Gate open position
is now programmed	Control
	Box

The gate open position is now programmed. If you make a mistake and set the limit at the wrong position: press your transmitter to return the gate to the fully closed position, then press and hold the LEARN MAST LIMIT button for 5 seconds. This will clear the memory for the open limit position. Repeat Steps 1-5.

22GTO 4000XLS Instruction Manual © 01.10.12