GTO UL325 SERIES Obstruction Sensitivity Potentiometer Setting, Setting Auto-Close Time

Obstruction Sensitivity Potentiometer Setting

IMPORTANT: For safety reasons the obstruction setting or Stall Force on the Mighty Mule® control board comes from the factory set at MIN (minimum). In many gate installations this setting will need to be adjusted to overcome the weight and size of the gates.

The Stall Force potentiometer on the control board operates like a volume control on a radio. It controls the obstruction sensitivity (or the amount of force the opener will apply to an obstruction) before it automatically stops and reverses direc- tion for approximately two (2) seconds.

Use a small slotted screwdriver to turn the arrow in the center of the potentiometer. Adjust the sensitivity from the MINI- MUM position where the gate operates without obstructing from its own weight or the wind conditions in your area.

MINMAX

STALL FORCE

CHARGING

POWER

STATUS

MIN MAX

STALL FORCE

OFF 120

CLOSE TIME

SET LEARN

LIMIT REMOTE

	ON	PULL-PUSH
1
2		MODE1
3		MODE2
4		LOCK/BEACON

RF

NOTE: You may need to increase the stall force in cold weather due to increased resistance from gate hinges.

LINK

	18VAC	EXIT	SAFETY	EDGE	CYCLE	COMMON	GRN	RECRBLK	RED
PANEL
SOLAR

ALWAYS KEEP SAFETY AT THE TOP OF YOUR LIST WHEN ADJUSTING OR

SERVICING YOUR AUTOMATIC GATE OPENER!

Setting Auto-Close Time

CLOSE TIME (auto close timer): Determines how long the gate will remain open before it automatically closes. The limits are OFF to 120 seconds. The factory setting is OFF.

OFF 120

CLOSE T IME

CHARGING

POWER

STATUS

MIN MAX

STALL FORCE

OFF 120

CLOSE TIME

SET LEARN

LIMIT REMOTE

	ON	PULL-PUSH
1
2		MODE1
3		MODE2
4		LOCK/BEACON

RF

LINK

		18VAC	EXIT	SAFETY	EDGE	CYCLE	COMMON	GRN	RECRBLK	RED
OUT
		PANEL
	SOLAR

25