GTO UL325 SERIES Step, Testing Your Open Limit Setting, Clearing Programmed Open Limit Setting

Step 3

With the gate in the desired open position PRESS & HOLD the “SET LIMIT" button on the control board for 5 seconds.

Step 4

Press the transmitter button and allow the gate to return to the closed position.

YOUR GATE’S OPEN POSITION LIMIT IS NOW PROGRAMMED.

TESTING YOUR OPEN LIMIT SETTING:

Press your entry transmitter and allow your gate to open. If the OPEN position is not correct or need to be changed, you will need to CLEAR your OPEN LIMIT settings and follow steps one (1) to four (4) again.

CLEARING PROGRAMMED OPEN LIMIT SETTING:

If you make a mistake and set the limit at the wrong position – press your transmitter to return the gate to the closed position, then press and hold the "SET LIMIT" button for 5 seconds. This will clear the memory for the open limit position. Follow steps one (1) to four (4) again.

STATUS
	MIN	MAX
	STALL FORCE
SET LIMIT Button
	OFF	120
	CLOSE TIME
	SET	LEARN
	LIMIT	REMOTE
1	ON PULL-PUSH
2	MODE1
3	MODE2
4	LOCK/BEACON
CHARGING		RF
POWER

LINK

	18VAC	EXIT	SAFETY	EDGE	CYCLE	COMMON	GRN	RECRBLK	RED
PANEL
SOLAR

35