Xacti Link

BASIC OPERATION

This is a system control function by which, through an HDMI cable, a control signal is output to electronic devices and the operation of multiple devices is coordinated. The HDMI-CEC function will operate correctly only when the Xacti whose model is VPC-HD1010, VPC-HD2000, VPC-FH1, VPC-TH1 or VPC-WH1 is connected to a SANYO TV that incorporates the HDMI-CEC function.

1Select HDMI SETTING in SETUP menu. Then press ◄► buttons to enter HDMI SETTING menu.(Figure A.) Select "XACTI LINK ON" by pressing ◄► buttons. (The details for operation, please refer to "SETUP" on page 38.)

2Select "HDMI-CEC ON" in Xacti menu as Figure B.

( For the details, please refer to "TV OUTPUT SETTING" on the INSTRUCTIONS MANUAL(Xacti).)

3Make sure that HDMI input is connected to Xacti if Xacti button is pressed. (The connecting way, please refer to "Connecting to the HDMI terminal" on the INSTRUCTIONS MANUAL(Xacti).) After connecting the Xacti to the television, switch the TV input to the terminal which the Xacti is connected.

4Press Xacti button to enter DISPLAY mode.(Figure C.) Press ▲▼ buttons to select any picture. Press OK button to display selected picture. And you can operate the selected picture by following buttons on Remote Control.

(Note: For the details, please refer to INSTRUCTIONS MANUAL(Xacti).)

●RED(W) button: Works the same as pushing zoom switch

toward the [W] side.

●GREEN(T) button: Works the same as pushing zoom switch toward the [T]side

●YELLOW button: It operates as a preservation button to

the animation edit.

●BLUE(MENU) button: Open or close the Xacti menu.

5Press Xacti button or RED button to return to the DISPLAY mode.

6To exit Xacti mode, select "XACTI LINK OFF" in HDMI LINK menu. (The details for operation, please refer to "SETUP" on page 38.)

REMOTE CONTROL

OK button