Computer

WIRELESS MEMORY

LAN

USB

wireless LAN module (supplied)

The USB wireless LAN module contains memory. You can switch the built-in memory and wireless connection with the slide switch. To install the Projector Station for Air Shot Version 2, slide the switch to MEMORY. To use the wireless connection, slide it to WIRELESS LAN.

2 Connect the supplied USB wireless LAN module to the USB terminal of the computer.

The window for installing the Projector Station for Air Shot Version 2 appears.

Notes

•If the above window does not appear, click [My Computer]-[USB_CD-ROM]- [Dp_Inst].

•You cannot refer to the Operating Instructions. See the Operating Instructions from the CD-ROM.

3 Select [Projector Station for Air Shot Version 2] and then click [Install].

4 Install the software according to the “wizard” within the installer.

5 Use [Safe to remove hardware] to stop the device and then remove the USB wireless LAN module. Then slide the switch to [WIRELESS LAN] and connect the USB wireless LAN module into the USB terminal.

When you use Windows XP Service Pack 2 and the following dialog box appears during installation, check the [Register automatically] check box and click [Next].

The [Autoconfiguration done] appears after the installation is completed.

6 To go on projecting the pictures, check the [Start Air Shot v2 and connect to Projector] check box and click [OK].

With the check, the Projector Station for Air Shot Version 2 starts up automatically. Without the check, the installer is completed.

When you are not going to project the pictures, click [OK].

Preparation 5