3.NOTE: The back side of the Front Rail (part #7H) has two slots. Slide the upper slot of the Front Rail over the Square Head Bolts (part #10H). (See Figures F, G, and Assy. Diagram H.)
(FRONT EDGE)
10” TABLE SAW/EXTENSION
TABLES (#5H)
SQUARE HEAD BOLT (#10H)
(UPPER SLOT)
HEX NUT (#13H)
FRONT RAIL (#7H)
WASHER (#12H)
SWITCH PLATE | (LOWER SLOT) |
(#3E) |
|
SQUARE
NUT(#4E)
FIGURE G
4.To align the Front Rail (part #7H), match the
5.Wrench tighten all five Square Head Bolts (part #10H). (See Figures F, G, and Assy. Diagrams G, and H.)
6.Secure the Right/Front End Cap (part #8H) and Left/Front End Cap (part #9H) to the Front Rail (part #7H), using one Tapping Screw (part #1H) on each end. (See Assy. Diagram H.)
To Attach The Rear Rail:
1.NOTE: The procedure for attaching the Rear Rail (part #3H) to the 10" Table Saw is similar to that of attaching the Front Rail (part#7H) to the Table Saw. (See “To Attach The Front Rail” section, Figures I, J, and Assy. Diagram H.)
2.Insert five Square Head Bolts (part #10H) through the mounting holes in the rear edges of the 10" Table Saw and Extension Tables (part #5H). Allow the bolt heads to extend out about 1/2". (See Figures I, J, and Assy. Diagram H.)
SKU 46813 | PAGE 13 |
