3.Attach one Short Leg Brace (part #9B) to the lower mounting holes in two Legs (part #4B), using one Carriage Bolt (part #5B), one Washer (part #3B), and one Hex Nut (part #2B) for each Short Leg Brace. Repeat the assembly procedure for the remaining one Short Leg Brace and two Legs.
(See Figure B, and Assy. Diagram B.)
4.Attach one Side Brace (part #7B) to the upper mounting holes in two Legs (part #4B), using two Carriage Bolts (part #5B), two Washers (part #3B), and two Hex Nuts (part #2B) for each Side Brace. Repeat the assembly procedure for the remaining one Side Brace and two Legs. (See Figure B, and Assy. Diagram B.)
5.Attach one End Brace (part #6B) to the upper mounting holes in two Legs (part #4B), using two Carriage Bolts (part #5B), two Washers (part #3B), and two Hex Nuts (part #2B) for each End Brace. Repeat the assembly procedure for the remaining one End Brace and two Legs. (See Figure B, and Assy. Diagram B.)
6.Screw one Hex Nut (part #2B) onto the threads of each of the four Leveling Feet (part #1B). Then, insert one Washer (part #3B) onto the threads of each of the Leveling Feet. Insert a Leveling Foot, with its threaded portion pointing upward, through the hole located at the bottom of each of the four Legs (part #4B). Insert one Washer (part #3B) onto the threads of each of the Leveling Feet. Then, screw one Hex Nut (part #2B) onto the threads of each of the four Leveling Feet. (See Figure B, and Assy. Diagram B.)
7.Move the Leg Assembly to the desired floor surface working location. Adjust the Leveling Feet (part #1B) so that the entire Leg Assembly stands level. Then, firmly tighten all hardware, using an appropriate size wrench (not provided). (See Figure B, and Assy. Diagram B.)
To Mount The Leg Stand On The 10" Table Saw Base:
1.With assistance, place the 10" Table Saw upside down on a flat, level, smooth surface (i.e., cardboard) on the floor. Then, place the Leg Assembly upside down on the Base (part #1G) of the 10" Table Saw. (See Figure D.)
2.Align the two mounting holes on the each of the two End Braces (part #6B) with the two mounting holes on each end of the Base (part #1G). Secure the End Braces to the Base, using four Hex Head Bolts (part #8B), eight Washers (part #3B), and four Hex Nuts (part #2B). (See Figure D, and Assy. Diagram B.)
3.NOTE: Leave the 10" Saw Table upside down for the next assembly procedure.
SKU 46813 | PAGE 10 |
