3.Secure the Motor Bracket (part #7F) to the Motor Mounting Plate (part #50-I), using four Hex Head Bolts (part #9-I), eight Washers (part #52-I), four Lock Washers (part #1-I), and four Hex Nuts (part #51-I).
(See Figure N, and Assy. Diagrams F, and I.)
LOCK
WASHER
WASHER
BELT GUARD
HEX HEAD BOLT (#9-I)
MOUNTING SCREW
| MOTOR MOUNTING PLATE |
MOTOR (#7F) | (#50-I) |
(USE TWO SETS OF HARDWARE AT TOP, TWO SETS AT BOTTOM.)
FIGURE N
4.Position the Spring (part #46-I) between the Motor Mounting Plate (part #50-I) and Motor Support Base (part #45-I). (See Assy. Diagram I.)
5.With the Spring (part #46-I) in place, insert the Motor Support Base (part #45-I) in the Motor Mounting Plate (part #50-I). Secure the Motor Support Base to the Motor Mounting Plate by inserting the Pivot Shaft (part #48-I) through the two parts. Then, lock the Pivot Shaft in place, using two Retaining Rings (part #47-I). (See Assy. Diagram I.)
6.Insert the two Rods in the Motor Support Base (part #45-I) into the two holes in the Trunnion Cradle (part #36-I). Push the Motor (part #7F) in as far as it will go. Then, Thread the two Set Screws (part #42-I) downward into the Trunnion Cradle to clamp down on the two Rods. NOTE: Do not securely tighten the two Set Screws yet. (See Assy. Diagram I.)
To Attach The Belt Guard:
1Open the hinged Belt Guard (parts #1F, #4F) and insert its round opening over the Motor Pulley (part #5F). (See Figures N, O, and Assy. Diagram F.)
