6.Once the 10" Saw Blade (part #14-I) is secured onto the Arbor Shaft (part #13-I), replace the Throat Plate (part #15H) and tighten the Flat Head Screw (part #16H) back in place. (See Figure Q, and Assy. Diagram H.)

To Attach The Blade Guard Assembly:

1.Unscrew and temporarily remove the Flat Head Screw (part #16H)) located at the front of the Throat Plate (part #15H)). Then, remove the Throat Plate to expose the 10" Saw Blade opening. (See Figures Q, R, and Assy. Diagram H.)

2.Place the Blade Guard Assembly (parts #1D Through 13D) over the Saw Blade opening on the Saw Table (part #17H). (See Assy. Diagrams D, and H.)

3.Insert two Socket Head Screws (part #5D) and two Washers (part #4D) in the two holes at the back of the Riving Knife (part #6D. Tighten the two Socket Head Screws, with Washers, into the Blade Guard Bracket (part #3-I).

(See Figure T, and Assy. Diagrams D, and I.)

4.Insert and tighten the third Socket Head Screw (part #5D) and one Washer (part #4D) into the threaded mounting hole in the Saw Table (part #17H) under the Throat Plate (part #15H). (See Figure T, and Assy. Diagrams D, and H.)

5.Once the Blade Guard Assembly (parts #1D through #13D) is secured onto the Saw Table (part #17H), replace the Throat Plate (part #15H) and tighten the Flat Head Screw (part #16H) back in place. (See Figure Q, and Assy. Diagram H.)

 

 

SOCKET HEAD SCREW(#5D)

 

 

WASHER (#4D)

 

 

 

 

 

 

 

BLADE GUARD (#10D)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

)

 

 

 

 

 

 

 

 

 

IFE

(#6D

 

 

 

 

 

 

 

K

N

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

G

 

 

 

 

 

 

 

 

IN

 

 

 

 

 

 

 

 

IV

 

 

 

 

 

 

 

 

R

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

BLADE GUARD

 

 

 

 

 

 

 

 

 

 

BRACKET (#3-I)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

FIGURE T

 

 

 

 

 

 

 

 

SKU 46813

 

PAGE 22

 

 

 

 

Page 22
Image 22
Harbor Freight Tools 46813 manual Figure T