END BRACE (#6B)
END BRACE (#6B)
MOUNTING HOLES
HEX
NUT
WASHER (#2B)
(#3B)
BASE (#1G)
HEX HEAD | BASE |
BOLT (#8B) | (#1G) |
FIGURE D
To Assemble The Extension Tables:
1.With the 10" Table Saw upside down, align the right and left side Extension Tables (part #5H) with the right and left ends of the Table Saw (with the beveled edges in front). (See Figure E, and Assy. Diagram H.)
2.Align the four mounting holes in each Extension Table (part #5H) with the four mounting holes on each end of the 10" Table Saw. Then secure the Extension Tables to the Table Saw, using four Hex Head Bolts (part #11H), eight Washers (part #12H), and four Hex Nuts (#13H). (See Figure E, and Assy. Diagram H.)
3.With assistance, stand the 10" Table saw upright.
To Attach The Front Rail:
1.Insert five Square Head Bolts (part #10H) through the mounting holes in the front edges of the 10" Table Saw and Extension Tables (part #5H). Allow the bolt heads to extend out about 1/2". (See Figure F, and Assy. Diagram H.)
2.Loosely attach a Washer (part #12H) and Hex Nut (part #13H) to each Square Head Bolt (part #10H). (See Figure F, and Assy. Diagram H.)
SKU 46813 | PAGE 11 |
