3.To adjust the bevel of the 10" Saw Blade (part
To Adjust The Angle Of A Cut:
1.The 10" Table Saw is capable of making miter cuts from 0 degrees to 60 degrees.
2.The Miter Gauge (part #4A) features a Miter Scale Indicator (part #6A) on the front side of the unit. (See Figure B, and Assy. Diagram A.)
3.To adjust the angle of a cut, loosen the Miter Gauge Knob (part #2A). Next, move the Miter Gauge (part #4A) to the right or left, until the desired angle of cut is shown by the Miter Scale Indicator (part #6A). Then, retighten the Miter Gauge Knob. (See Figure B, and Assy. Diagram A.)
Proper Placement Of Hands During The Cutting Process:
1.Caution: NEVER pass hands directly over or under the 10" Saw Blade (part
(See Figure B, and Assy. Diagram.)
2.At the start of the cut, the left hand holds the workpiece firmly on the Saw Table (part #17H) and against the Rip Fence (part #10C). The right hand, with the aid of a push stick, pushes the workpiece toward the turning 10" Saw Blade (part
3.After the cut is under way, the right hand with the aid of a push stick, continues pushing the workpiece forward. Just before the cut is near completion move the left hand safely away from the workpiece and the 10" Saw Blade (part
INSPECTION, MAINTENANCE, AND CLEANING
1.Caution: Always disconnect the 10" Table Saw from its electrical power supply source before performing any inspection, maintenance, or cleaning.
SKU 46813 | PAGE 24 |