¯ | ( | ˜ | Û $ | ˆ | & | ı | Ù Ú |
AVR 235 |
|
|
|
|
|
|
|
1 3 | 8 5 |
| ) ! 7 | % | * Ó |
| |
2 | 4 6 | 9 | 7 @ # |
| ^ | Ô | Ò |
1 Main Power Switch |
2 System Power Control |
3 Power Indicator |
4 Headphone Jack |
5 Surround Mode Group Selector |
6 Speaker Select Button |
7 Selector Buttons |
8 Tone Mode |
9 Surround Mode Selector |
)Tuning |
!Tuner Band Selector | ÔVideo 4 input jacks |
@Set Button | Bass Control |
#Preset Stations Selector | ÒBalance Control |
$Speaker/Channel Input Indicator | ÚTreble Control |
%Input Source Selector | ÛDigital Input Selector |
^RDS Select Button | ÙChannel Select Button |
&Delay | ıVolume Control |
*Digital Optical 3 Input | ˆInput Indicators |
(Surround Mode Indicators | ˜Main Information Display |
ÓDigital Coax 3 Input | ¯Remote Sensor Window |
1 Main Power Switch: Press this button to |
apply power to the AVR. When the switch is |
pressed in, the unit is placed in a Standby |
mode, as indicated by the orange LED 3. This |
button MUST be pressed in to operate the unit. |
To turn the unit off completely and prevent the |
use of the remote control, this switch should be |
pressed until it pops out from the front panel so |
that the word “OFF” may be read at the top of |
the switch. |
NOTE: This switch is normally left in the “ON” position.
2System Power Control: When the Main Power Switch 1is “ON,” press this button to turn on the AVR; press it again to turn the unit off (to Standby). Note that the Power Indicator 3will turn blue when the unit is on.
3Power Indicator: This LED will be illuminated in orange when the unit is in the Standby mode to signal that the unit is ready to be turned on. When the unit is in operation, the indicator will turn blue.
4Headphone Jack: This jack may be used to listen to the AVR’s output through a pair of head- phones. Be certain that the headphones have a standard 6.3 mm stereo phone plug. Note that the speakers will automatically be turned off when the headphones are connected.
5Surround Mode Group Selector: Press this button to select the
Dolby Modes ➜ DTS Digital Modes ➜ DSP Modes ➜ Stereo Modes ➜ Logic 7 Modes
Once the button is pressed so that the name of the desired surround mode group appears in the Main Information Display ˜, press the Surround Mode Selector 9to cycle through the individual modes available. For example, press this button to select Dolby modes, and then press the Surround Mode Selector 9to choose from the various mode options.
6Speaker Select Button: Press this button to begin the process of selecting the speaker positions that are used in your listening room. (See page 16 for more information on setup and configuration.)
FRONT PANEL CONTROLS 5