System Configuration
If you wish to customize the speaker size individ- ually to each input, make certain that the cursor is on the BASS MGR line and press the ‹/› Buttons E so that INDEPENDENT appears in highlighted video. When this setting is entered all speaker size settings will be shown with their factory default size in the menu and all other inputs will turn to INDEPENDENT too. Now you should enter the speaker size settings prefered for the input selected, as described below. Remember that in this case the size set- tings just entered will apply to the current input ONLY, and you will need to go back to the INPUT menu to select another input, and then return to this menu page again to change the settings for the next input. Repeat the procedure for any input where you wish to have a set of speaker configuration different from the default settings.
2.Begin the speaker size setup process by making certain that the cursor is pointing toward the LEFT/RIGHT line, which sets the configura- tion for the front left and right speakers. If you wish to make a change to the front speakers’
configuration, press the ‹/ › Buttons E so that either LARGE or SMALL appears, match- ing the appropriate description from the definitions shown above.
When SMALL is selected,
When LARGE is selected, a
NOTE: When the front speakers are set to the LARGE option and the surround mode is set to "Surround Off", or pure
Important Note: When a speaker set with a subwoofer and two front satellites connected to the Sub´s speaker outputs is used, the Sub´s inputs must be connected to the Front speaker outputs and LARGE must be selected for the front speakers (and NONE for the sub- woofer, see below).
3.When you have completed your selection for the front channel, press the ¤ Button Don the remote to move the cursor to CENTER.
4. Press the ‹/› Buttons E on the remote to select the option that best describes your center speaker, based on the speaker definitions shown below.
When SMALL is selected,
When LARGE is selected, a
NOTE: If you choose Logic 7 as the surround mode for the particular input source for which you are configuring your speakers, the AVR will not make the LARGE option available for the center speaker. This is due to the requirements of Logic 7 processing, and does not indicate a problem with your receiver.
When NONE is selected, no signals will be sent to the
5.When you have completed your selection for the center channel, press the ¤ Button D on the remote to move the cursor to
SURROUND.
6. Press the ‹/› Buttons E on the remote to select the option that best describes the sur- round speakers in your system based on the speaker definitions shown on page 19.
When SMALL is selected, with all digital sur- round modes
When LARGE is selected, a
When NONE is selected,
When you are using surround back speakers with your system, press the ¤ Button Don the remote to move the cursor to SURR BACK. This line serves two functions in that it not only configures the setting for the surround back channels when they are present, it also tells the AVR’s processing system to configure the unit for either 5.1 or 6.1/7.1 operation.
Press the ‹/ › Buttons on the remote to select the option that best describes the speakers in use at the left and right back surround positions based on the definitions on this page:
When NONE is selected, the system will adjust so that only
When SMALL is selected the system will adjust so that the full complement of 6.1/7.1 surround processing/decoding modes are available, and
When LARGE is selected the system will adjust so that the full complement of 6.1/7.1 surround processing/decoding modes are available, and a
7.When you have completed your selection for the surround channels, press the ¤ Button D on the remote to move the cursor to
SUBWOOFER.
8. Press the ‹/› Buttons E on the remote to select the option that best describes your system.
18SYSTEM CONFIGURATION