Hearth and Home Technologies BE-36-C Appliance Setup, Remove Shipping Materials, Accessories

12 Appliance Setup

A. Remove Shipping Materials

Remove shipping materials from inside or underneath the firebox.

B. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated inside the firebox or underneath in the control cavity.

WARNING

Explosion Risk.

•Follow ember placement instructions in manual.

•Do NOT place embers directly over burner ports.

•Replace ember material annually.

Improperly placed embers interferes with proper burner operation.

C. Accessories

Install approved accessories per instructions included with accessories. See Service Parts List for appropriate acces- sories. Refer to Section 16.

WARNING

Shock or fire risk.

Use ONLY optional accessories approved for this appliance.

•Using non-listed accessories voids warranty.

•Using non-listed accessories may result in a safety hazard.

•Only Hearth & Home Technologies approved

accessories may be used safely.

Placing the Ember Material

Ember material is shipped with this gas appliance. To place the ember material:• Embers CANNOT be placed di- rectly over ports. Care should be taken not to cover the lighting trail of ports (from back to front).

•When placing Glowing Embers® onto the burner care should be taken so that the ports are not covered. Place the dime-size ember pieces near the port holes in the burner top (see Figure 12.1). Failure to follow this pro- cedure will likely cause lighting and sooting problems.

EMBER MATERIALS

Figure 12.1 Placement of Embers

•Place lava rock on base pan on both sides of the burner. Do NOT place on burner top.

•Save the remaining ember materials for use during appli- ance servicing. The embers provided should be enough for 3 to 5 applications.

Hearth & Home Technologies • BE-36-C, BE-36-CIPI • 397-981 Rev. V 1/07 41