FOR YOUR SAFETY READ BEFORE LIGHTING

 

This appliance needs fresh air for safe operation and must

 

 

 

combustion and ventilation air.

 

 

 

 

 

 

 

 

 

 

 

 

 

be installed so there are provisions for adequate

 

 

 

 

 

WARNING:

If you do not follow these instructions exactly, a

 

 

 

This appliance must be installed in accordance

 

 

 

 

 

 

fire or explosion may result causing property

 

 

 

 

 

 

 

 

 

 

 

with local codes, if any; if not, follow ANSI

 

 

 

 

 

 

damage, personal injury or loss of life.

 

 

 

Z223.1 or, in Canada, current CAN/CGA-B149.

 

 

 

 

 

 

 

 

 

 

A.

This appliance is equipped with an ignition device which

 

• If you cannot reach your gas supplier, call the fire

 

This appliance must be properly connected to a

 

 

automatically lights the pilot. Do not try to light the pilot

 

department.

 

venting system in accordance with the

 

 

by hand.

 

C.

Use only your hand to push in and move the gas control

 

manufacturer's installation instructions.

 

B.

BEFORE LIGHTING smell all around the appliance area

 

 

 

 

 

 

 

WARNING: Improper installation,

 

 

lever or knob will not move by hand, don't try to repair it,

 

 

 

for gas. Be sure to smell next to the floor because some

 

valve or turn the gas control knob. Never use tools. If the

 

 

 

 

 

 

 

gas is heavier than air and will settle on the floor.

 

call a qualified service technician. Force or attempted

 

adjustment, alteration, service or maintenance

 

 

WHAT TO DO IF YOU SMELL GAS

 

 

 

 

 

 

 

repair may result in a fire or explosion.

 

can cause injury or property damage. Refer to

 

 

• Do not try to light any appliance.

 

D.

Do not use this appliance if any part has been under

 

the owner's information manual provided with

 

 

• Do not touch any electric switch; do not use any

 

water. Immediately call a qualified service technician to

 

the appliance. For assistance or additional

 

 

phone in your building.

 

 

inspect the appliance and to replace any part of the

 

information consult a qualified installer, service

 

 

• Immediately call your gas supplier from a neighbor's

 

control system and any gas control which has been

 

agency or the gas supplier.

 

 

phone. Follow the gas supplier's instructions.

 

 

 

 

 

under water.

 

CAUTION: Hot while in operation. Do not touch.

Heatilator

 

 

 

 

LIGHTING INSTRUCTIONS

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

having flammable vapors away.

 

 

 

 

 

 

 

 

 

 

 

 

 

Keep children, clothing, furniture, gasoline and other liquids

1.

STOP! Read the safety information above on this label.

5.

Wait five minutes to clear out any gas. If you then smell gas,

 

 

 

 

 

 

WARNING RISK OF FIRE

2.

Turn wall switch to the "OFF" position or thermostat to

 

STOP! Follow "B" in the safety information above on this label. If

 

Eclipse•

 

 

4.

the lowest setting.

 

 

you don't smell gas, go to the next step.

 

This appliance is equipped with an ignition device which

 

and turn on the wall switch or set the thermostat to the desired

 

not attempt to use with solid wood fuel or another type of fuel.

 

3.

Turn off all electric power to the appliance.

6.

To turn on the burner, turn on all electric power to this appliance

 

This appliance is intended to burn a specified gas fuel only. Do

4049

 

automatically lights the pilot. Do NOT try to light the pilot

 

setting.

 

Do not attempt to modify or use any other type of gas burner

 

by hand.

 

7.

If the appliance will not operate, follow the instructions "TO TURN

 

system.

-

 

 

 

 

 

 

 

OFF GAS TO APPLIANCE" and call your service technician or gas

 

 

 

 

 

 

 

TO TURN OFF GAS TO APPLIANCE

 

WARNING: Disconnect the electric power before

229Rev

 

 

 

 

 

 

 

 

 

 

 

supplier.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

servicing. If for any reason the original wire supplied with the

 

 

 

 

 

 

 

 

 

 

 

 

 

appliance must be replaced, it must be replaced with 105° C or its

F •

 

 

 

 

 

 

 

 

 

 

 

 

1.

Turn off wall switch or set thermostat to lowest setting.

3.

Push the gas control lever in and move to the "OFF"

 

equivalent.

 

11/08

 

For use with natural gas or propane. A conversion

2.

Turn off all electric power to the appliance if service is to

 

position or push the gas control lever to the "OFF"

 

 

 

be performed.

 

 

position. Do not force.

 

kit as supplied by the manufacturer shall be used

 

 

 

 

 

 

 

4.

Replace the control access panel.

 

to convert this appliance to the alternative fuel.

 

 

 

 

 

 

 

 

 

 

 

 

* Also certified for installation in a bedroom or

 

 

 

 

 

 

 

 

 

 

 

 

 

a bed-sitting room.

 

 

 

 

 

 

 

 

 

*

For U.S. only!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Due to high surface temperatures, keep children, clothing and furniture away.

 

 

NATURAL GAS

 

 

 

Keep burner and control compartment clean. See installation and operating instructions accompanying the appliance.

 

 

 

 

 

 

 

 

 

 

 

 

 

33631D

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

11

tery life, remove them when using the

H. Lighting Instructions (IPI) The IPI system may be operated with

transformer.

two D-cell batteries

 

.

 

When using batteries, unplug the transformer. To prolong bat-

Page 11
Image 11
Hearth and Home Technologies EDV3633L, EDV3633IL owner manual Lighting Instructions