14 Appliance Setup
A. Remove Fixed Glass Assembly
See Section 14.H.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the firebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated inside the firebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included with accessories. Contact your dealer for a list of ap- proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY Hearth & Home
F. Ember Placement
WARNING! Risk of Explosion! Follow ember placement instructions in manual. DO NOT completely block burner ports with ember material. Replace ember material annu- ally. Improperly placed embers interfere with proper burner operation.
Ember material is shipped with this gas appliance. To place the ember material:
•Embers CANNOT completely block burner ports. Care should be taken not to block the lighting trail of ports.
•Embers may only be placed in areas as shown in Figure 14.2.
•LP Only: Using
•Save the remaining ember materials for use during appliance servicing. The embers provided should be enough for 3 to 5 applications.
E. Burner Top Installation
1.Bend the two tabs upward as shown in Figure 14.1.
2.To install the fiber burner, mate the locating holes with the guide sleeves. Install fiber burner top so that it makes full contact with the underlying burner assem- bly.
3.Ensure that the ports in the steel burner are visible through the holes in the fiber burner top.
FIBER BURNER TOP | LOCATING HOLES | |
|
| |
BEND TABS UP |
| |
|
| AIR SCOOP |
BURNER ASSEMBLY |
| PILOT COVER |
|
| |
|
| BURNER SHIELD |
GUIDE SLEEVES |
|
|
EMBERS | NO EMBERS IN SHADED AREAS |
|
Figure 14.2 Placement of Embers
Figure 14.3 Embers Overlapping Burner Port Holes (LP only).
Figure 14.1
Heat & Glo • 6000C, | 61 |
