Heat & Glo LifeStyle 6000GLX-IPILP-S/-R Top Vent - Vertical Termination continued, Two Elbows

Top Vent - Vertical Termination (continued)

3.Match the amount of vertical you have in the system with the chart to find the appropriate position to set the Flue Restrictor (see Figure 7.9).

Vertical	TOP VENT		REAR VENT
	NG	LP	NG	LP
4 ft.	1-1	No	No	No
		Restrictor	Restrictor	Restrictor
8 ft.	2-2	1-2	1-1	No
				Restrictor
15 ft.	3-3	3-2	2-2	1-2
20 ft.	3-4	3-3	3-3	2-3
25 ft.	3-4	3-3	3-3	2-3
30 ft.	4-4	3-4	3-4	3-3
35 ft.	4-4	3-4	3-4	3-3
40 ft.	5-4	4-4	4-4	3-4

Figure 7.9

Note: If the DVP-2SL adapter and SLP pipe is used, you MUST subtract one number from the table above.

Example: Top vent 40 ft vertical with DVP pipe = 5-4 Top vent 40 ft vertical with SLP pipe = 4-3

Two Elbows

V2

H1

Figure 7.11

4. Center the Flue Restrictor on vent and secure in place by using two self-tapping screws (see Figure 7.10).

5. Reinstall the Exhaust Shield.

1 2 3 4 5

SETTING

1 2 3 4 5

Figure 7.10

	V1	H1 Maximum		V2	V1 + V2 Min.
Elbow only		2 ft.	610 mm	*	*	*
6 in.	152 mm	6 ft.	1.8 m	*	*	*
2 ft.	610 mm	11 ft.	3.4 m	*	*	*
3 ft.	914 mm	16 ft.	4.9 m	*	*	*
4 ft.	1.2 m	20 ft	6.1 m	*	*	*

V1 + V2 + H1 = 50 ft (15.2 m) Maximum

*No specific restrictions on this value EXCEPT V1 + V2 + H1 cannot exceed 50 ft (15.2 m)

V1

Heat & Glo • 6000GLX-IPI-S/-R, 6000GLX-IPILP-S/-R • 2101-900 Rev. Q • 11/08 27