Heat & Glo LifeStyle 6000GLX-IPILP-S/-R E. Junction Box Installation, NOTICE: DO NOT wire

E. Junction Box Installation

If the box is being wired from the INSIDE of the appliance:

•Remove the screw attaching the junction box/receptacle to the outer shell, rotate the junction box inward to disengage it from the outer shell (see Figure 12.2).

•Pull the electrical wires from outside the appliance through the opening into the valve compartment and secure wires with a Romex connector. See Figure 12.2.

•Make all necessary wire connections to the junction box/ receptacle and reattach the junction box/receptacle to the outer shell.

	Romex
	Connector
	14/2WG
	Cover Plate
	outside firebox
WHT
BLK
WHT
BLK	Copper
GRN wire	ground attached
	to GRN screw with
inside box
	GRN wire
NOTICE: DO NOT wire
110 VAC to wall switch.
Figure 12.2 Junction Box Detail

F. Wall Switch Installation for Fan (Optional)
If the box is being wired to a wall mounted switch for use
with a fan (See Figure 12.3):		Minimum 14-3 AWG		Switch
•	The power supply for the appliance must be brought into
		with Ground
	a switch box.		Red
			Black	Black
			White	White
•	The power can then be supplied from the switch box to the	Junction Box	Green	Green
	appliance using a minimum of 14-3 with ground wire.	Red Black White	Green
•	At the switch box connect the black (hot) wire and red			Power
			Switch Box
				Supply
	(switch leg) wire to the wall switch as shown.
				Wires
•	At the appliance connect the black (hot), white (neutral)		Knockout
	and green (ground) wires to the junction box as shown.
• Add a 1/4 in. insulated female connector to the red (switch		Red
	leg) wire, route it through the knockout in the face of the
	junction box, and connect to the top fan switch connector	Figure 12.3 Junction Box Wired to Wall Switch or BC10
	(1/4 in. male) as shown.
	Heat & Glo • 6000GLX-IPI-S/-R, 6000GLX-IPILP-S/-R • 2101-900 Rev. Q • 11/08			49